Chevrolet Cruze manuals

Chevrolet Cruze Owners Manual: Brake System Messages

BRAKE FLUID LOW

This message is displayed when the brake fluid level is low.

RELEASE PARKING BRAKE

This message is displayed as a reminder that the parking brake is on. Release it before you attempt to drive.

Battery Voltage and Charging Messages
BATTERY SAVER ACTIVE This message displays when the vehicle has detected that the battery voltage is dropping beyond a reasonable point. The battery saver system starts reducing features of the v ...

Compass Messages
CAL This message is displayed when the compass needs to be calibrated. – – Two dashes will be displayed if the compass needs service. See your dealer for service. ...

Other materials:

Front Fender Emblem/Nameplate Replacement (1.8L 2H0 or 2.0L Diesel)
Front Fender Emblem Assembly Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section. Procedure The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop suff ...

Brake Pedal Position Sensor Calibration
Calibration Criteria Note: Do not apply the brake pedal during the brake pedal position (BPP) sensor calibration procedure. Any movement of the brake pedal during this procedure will cause the calibration procedure to fail. If this occurs, the sensor calibration must be repeated. Brake pedal ...

Steering Linkage Inner Tie Rod Replacement (Electronic Power Steering)
Special Tools CH-6247 Removal and Installation Tool for the Steering Linkage Inner Tie Rod For equivalent regional tools, refer to Special Tools. Removal Procedure Raise and support the vehicle. Refer to Lifting  and Jacking the Vehicle. Remove the tire and wheel assembly. Refer to ...

© 2011-2026 Copyright www.ccruze.com