Service Manuals
Service Manuals have the diagnosis and repair information on the engines, transmission, axle, suspension, brakes, electrical, steering, body, etc.
Service Bulletins
Service Bulletins give additional technical service information needed to knowledgeably service General Motors cars and trucks.
Each bulletin contains instructions to assist in the diagnosis and service of the vehicle.
Owner Information
Owner publications are written specifically for owners and intended to provide basic operational information about the vehicle. The Owner Manual includes the Maintenance Schedule for all models.
In-Portfolio: Includes a Portfolio, Owner Manual, and Warranty Manual.
RETAIL SELL PRICE:
$35.00 (U.S.) plus handling and shipping fees.
Without Portfolio: Owner Manual only.
RETAIL SELL PRICE:
$25.00 (U.S.) plus handling and shipping fees.
Current and Past Models
Technical Service Bulletins and Manuals are available for current and past model GM vehicles.
ORDER TOLL FREE:
1-800-551-4123 Monday – Friday 8:00 AM – 6:00 PM Eastern Time
For Credit Card Orders Only (VISA-MasterCard-Discover), see Helm, Inc. at: www.helminc.com.
Or write to:
Helm, Incorporated
Attention: Customer Service
47911 Halyard Drive
Plymouth, MI 48170
Prices are subject to change without notice and without incurring obligation. Allow ample time for delivery.
All listed prices are quoted in U.S.
funds. Make checks payable in U.S.
funds.
Rear Side Door Stationary Window Replacement
Preliminary Procedures
Remove the rear side door trim panel. Refer to Rear Side Door Trim
Replacement.
Remove the rear side water deflector. Refer to Rear Side Door Water
Deflector Replacement.
Remove the rear door window outer sealing strip. Refer to Rear Side Door
Window ...
Hood
To open the hood:
1. Pull up on the hood release handle. It is located inside the vehicle to the
left of the steering column.
2. Go to the front of the vehicle and push the secondary hood release handle
toward the driver side of the vehicle.
3. Lift the hood and release the hood prop fr ...
Installation Procedure
Cut the rocker outer panel in corresponding locations to fit the
remaining original panel. The sectioning joint should be trimmed to
allow a gap of one-and-one-half-times the metal thickness at the sectioning
joint.
Create 50 mm (2 in) backing plates from the unused portion of the
...