Special Tools
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Collision Sectioning Warning in the Preface section.
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.
Disable the SIR System. Refer to SIR Dis ...
Headlamp Replacement
Preliminary Procedure
Remove the front bumper fascia upper bracket. Refer to Front Bumper Fascia
Replacement.
Headlamp Screw (Qty: 4)
Caution: Refer to Fastener Caution in the Preface section.
Tip
Secure the headlamp fasteners in sequence, as indicated.
Tighten
2.5 N·m (22 lb in)
...
Rear Compartment Lid Emblem/Nameplate Replacement (VCDi AT)
Rear Compartment Lid Emblem Assembly
Caution: Refer to Exterior Trim Emblem Removal Caution in the
Preface section.
Procedure
The part and surface should be 21°C (70°F) prior to installation. The
vehicle should remain 21°C (70°F) for
one hour after assembly to allow adhesive to deve ...